ROBBE RO-WING 300 Notice D'utilisation page 15

Reverse 2
Reverse 1
Ready LED
- Servo 1:
- Servo 2:
- Rx 1:
- Rx 2:
- AUX:
[single wire]
- Ready LED:
- Reverse 1:
- Reverse 2:
- Wire link:
The RO-WING 300 features a wire link whose purpose is to set up the gyro to suit the ori-
entation of the two aileron servos. The link takes the form of a loop of wire about 2 cm long
which emerges through the rubber grommet of the Rx1 cable, and enters the case through
the Servo 2 grommet. If the installed position of the servos requires it, you must cut through
the loop of wire (open link).
Both ends of the wire should then be insulated. If a different model requires the opposite
arrangement (closed link), you can solder the cut ends together; if you do this you must
insulate the soldered joint carefully.
Operating instructions
Gyro RO-WING-300
Servo 2 Rx1
Servo 1
Wire link
(loop of wire)
Socket for the function 1 servo, e.g. aileron 1.
Socket for the function 2 servo, e.g. aileron 2.
Cable for connection to receiver output 1, e.g. aileron 1.
Cable for connection to receiver output 2, e.g. aileron 2.
Cable for connection to the receiver output which controls
gyro gain
Monitor LED, shows that the gyro is ready for use when the automa
tic self-calibration process has been completed.
Micro-switch for reversing the direction of servo 1.
Micro-switch for reversing the direction of servo 2.
The link is used when required by the physical orientation of the two
aileron servos.
Closed link:
Gyro suppression in force when both servos are moved in the same
direction.
Gyro suppression not in force when servos are moved in opposite
directions.
Open link:
Gyro suppression not in force when both servos are moved in the
same direction
Gyro suppression in force when the servos are moved in opposite
directions.
The "Ready" LED lights up when the
gyro has successfully completed its
automatic self-calibration process
after being switched on; it is then
immediately ready for the next flight.
Rx2
The following connections and con-
trols are present on this gyro
system:
AUX
14
Order No.
8418