Activating The Ice Maker (Optional); Information Signals And Faults With The Display; Customisation And Language Setting - Bertazzoni REF75PIXL Manuel Utilisateur

4.3 Activating the Ice Maker (optional)

The Ice Maker button, located on the main control
panel, enables the ice maker.
The button is lit when this is operational.
Before starting up the ice maker for the first time,
check that the water filter has been inserted, and
perform an initial rinse of the water circuit. To do
so, press the Enter
simultaneously. After a few minutes, the Ice Maker
can be activated.
Ice maker (freezer 0F only)
unctions ce
F I M
ce aker /
I M on off
w ater f ilter
nter > onfirm
e c
Important
Do not enable the Ice Maker if the appliance
is not connected to the water supply.
4.4 Information Signals and Faults
with the Display
An integrated monitoring
information via symbols or messages shown on
the display.
Information is always displayed with stationary
text, while fault warnings are shown with flashing
text.
The audible warning which accompanies some
fault signals can be disabled by pressing the Alarm
button on the main control panel.
The list of fault signals is given at the end of this
manual.
10
and Ice Maker buttons
aker
ce aker
I M off
m anual c leaning
...
ottle ooler
b c
system provides
www.universal.bertazzoni.com
5. SETTINGS
5.1 Customisation and
Language Setting
To prevent accidental modification of the
settings, the keypad locks automatically
after a certain period of time, and the
message "keypad lock" is displayed.
To re-enable it, press and hold the Menu
and Fridge Down
for at least three seconds, or else press and
hold the Menu
three seconds.
The keypad lock can be deactivated via the
specific function in the Settings menu.
It is possible to customise the operation of your
Bertazzoni to adapt it to your requirements, via the
main settings or by activating special functions.
Functions are shown on the main display by pressing
the Menu button. The Up/Down
you to scroll through the available functions, which
can be selected by pressing the Enter
display will show the current status of the function.
The Up/Down buttons also allow you to move
around within the selected function, enabling it or
disabling it by pressing Enter
has been confirmed, the display will automatically
show the main menu to allow you to choose other
functions.
It is possible to return to the previous choice at any
time via the Menu button.
The language for the messages shown on the
display can be set as follows:
Access the menu by pressing the Menu
then use the Up/Down
and confirm with the Enter
the Language function and the required language.
buttons simultaneously
button alone for at least
buttons allow
button; the
. Once the function
button,
buttons to select Settings,
button. Then select