Max CN55 Manuel D'instructions D'utilisation page 6

FULL SEQUENTIAL The tool fires a nail.
ACTUATION In order to fire a second nail, you should
both release the Trigger and remove
the Contact arm from the surface.
DIRECTIONAL EXHAUST COVER (CN55, CN80)
(Fig.6)Loosen screw shown.
Adjust to desired exhaust direction and tighten screw.
REMOVING JAMMED NAILS (Fig.7)
WARNING
• ALWAYS disconnect the air supply.
• Wear gloves when removing jams; do not use bare hands
• Confirm that you have removed all nails from nose of tool
before reconnecting to air supply.
1 Disconnect the air supply.
2 Open the tool door and remove nails from inside of the mag-
azine.
3 Remove the jammed nail from the Nose using a punch or a
slotted screw driver.
4 Put back the nails on the feed pawl and close the tool door.
4