Switching On And Off - SPARKY Professional P 282 Instructions D'utilisation

REMOVING A PLANER BLADE
INSTALLING A PLANER BLADE
if required.
2. Slide the good blade face up into the blade sup-
NOTE. The ridge along the blade should be on the
blade face on the opposite side to the clamping
are tightened evenly.
4. Repeat for the remaining blade.
NOTE. Always change both blades at the same
time, otherwise the resulting imbalance can cause
vibration and shorten the blade and tool life.
NOTE.
going out from manufactory, so do not adjust the
two inner hex screws on blade supporter.
(Fig. 2) Correct
CAUTION:
clean out all chips or foreign matter adhering
selves. Use blades of the same dimensions
and weight, or the barrel will oscillate and vi-
brate causing poor planing action and possibly
a machine breakdown. Tighten the clamping
to the planer. A loose clamping screw could be
extremely dangerous. Regularly check to see
they are tightened securely.
NOTE. Your planing surface will end up rough and
uneven unless the blades are set properly and se-
curely. The blades must be mounted so that the
cutting edge is absolutely level, i.e. parallel to the
The examples below show proper and improper
Correct setting (Fig. 2)
Clean smooth cut (Fig. 4)
Nicks in surface
one or both not being parallel to the rear base
line. (Fig. 5)
Gouging at start
6
EN
pages-P282.indd 6
(Fig. 1)
(Fig. 2)
(Fig. 3) Incorrect
-
one or both not protruding enough in relation to
the rear base line. (Fig. 6)
Gouging at end
one or both protruding too far in relation to the
rear base line. (Fig. 7)
NOTE.
ADJUSTING THE THE PLANNING DEPTH
CAUTION! Always ensure that the tool is switched
off and unplugged from the power supply before
making adjustments or installing or removing
blades.
for a deeper cut and anti-clockwise for a shal-
lower cut. (Fig. 8)
2. The numbers on the ring under the depth ad-
example when "2" is next to the pointer on the
front of the planer, the depth of cut is approxi-
mately 2 mm.
3. If it is necessary to accurately determine the
depth of cut, plane a scrap piece of wood,
measure the difference in thickness and adjust
the setting if necessary.
CAUTION: Always ensure that the
the tool is not in use; at this position, the blade
can not cut the workpiece.

SWITCHING ON AND OFF

CAUTION:
chine into the power point always check that the
properly.
1. Plug in the machine, push in the lock-off button
2. To stop the tool, simply release the trigger
3. In order to restart the machine, it is necessary
feature that helps prevent accidental operation
of the planer.
PLANING
surface without the blades making any contact
with the workpiece.
-
(Fig. 9)
P 282