Maintenance; Warranty - SPARKY Professional P 282 Instructions D'utilisation

NOTE. Wear eye protection when cleaning out
the pulley area.
3. With the three continuous "V" profiles on the in-
side, place the new belt over the bottom pulley.
then roll the belt in place whilst turning the pul-
ley.
4. Check that the belt runs evenly by manually
turning the belt.
5. Replace the cover and the four fixing screws.
for a minute or two to make sure that the motor
and belt are operating correctly.
ACCESSORIES
Parallel guide; spare driving belt; spare set of 2
blades; dust bag; spanner.
VII - Maintenance
CAUTION: Always ensure that the tool
is switched off and unplugged before attempt-
ing to perform inspection or maintenance.
They may vibrate loose over time.
Re-lubricate all moving parts at regular intervals.
BRUSH REPLACEMENT
When the carbon brushes are worn out, both
brushes must be replaced simultaneously with
genuine brushes at SPARKY service centre for
warranty and post-warranty service.
CLEANING
its ventilation slots clean.
Regularly check to see if any dust or foreign matter
has entered the grills near the motor and around
the switches. Use a soft brush to remove any ac-
cumulated dust. Wear safety glasses to protect
your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a
soft damp cloth. A mild detergent can be used.
CAUTION:
to clean plastic parts.
8
EN
pages-P282.indd 8
CAUTION: Water must never come into
contact with the tool.
IMPORTANT! To assure product safety and reli-
uine replacement parts.
VIII - Warranty
The guarantee period for SPARKY power tools is
determined in the guarantee card.
er handling will be excluded from the guarantee.
well as defects in workmanship will be corrected
free of charge through replacement or repair.
The complaints for defective SPARKY power
back to the dealer or is presented to the author-
ised warranty service centre undismantled, in its
initial condition.
Notes
Carefully read the entire Instruction Manual before
using this product.
With continuing product development changes
may have occurred which render the product
received slightly different to that shown in this in-
struction manual. The manufacturer reserves the
-
-
-
P 282