Drive Belt Replacement - SPARKY Professional P 282 Instructions D'utilisation

2. Switch on the tool and wait for the blades to
reach full speed.
3. Move the tool gently forward, applying pressure
on the front of the tool, using your hand on the
pressure at the rear of the tool, using your hand
planing stroke.
4. Push the planer beyond the edge of the work-
piece without tilting it downwards.
NOTE. Planing is easier if you incline the work-
piece slightly away from you so that you plane
"downhill".
5. The rate of planing and the depth of cut deter-
you can increase the depth of cut, however to
achieve a good finish you will need to reduce
the depth of cut and advance the tool more
slowly.
CAUTION: Moving the machine too fast
may cause a poor quality of cut and can dam-
age the blades or the motor. Moving the ma-
chine too slowly may burn or mar the cut.
The proper feed rate will depend on the type of
material being cut and the depth of the cut.
the correct feed rate and the cut dimensions.
CAUTION: Always use two hands to
hold the planer. Where possible, clamp the
workpiece to the bench.
CHAMFERING AND REBATING
1. To make a chamfered or rebate cut as shown
in (Fig. 10).
(Fig. 11)
the corner edge of the workpiece.
2. Run the planer along the corner edge.
r
NOTE.
(Fig. 10)
(Fig. 11)
PARALLEL FENCE GUIDE
CAUTION: Always ensure that the tool
is switched off and unplugged from the power
supply before making adjustments or installing
or removing blades.
Instruction Manual
pages-P282.indd 7
fence guide on to the planer (Fig. 12, 13).
NOTE.
ing plate of the fence locate over the two lugs on
the planer body.
tighten it firmly (Fig. 14).
3. Loosen the wing nut securing the fence slide,
position the slide to the desired rebating width
and re-tighten the wing nut.
4. The numbers on the fence indicate the rebating
5. If it is necessary to rebate to a precise width,
plane a scrap piece of wood, measure the re-
bate distance and adjust the setting if neces-
sary (Fig. 15).
SHAVINGS EXTRACTION
1. Depending on which side of the planer you wish
ings to flow either to the left or to the right of the
workpiece.
(Fig. 16).
Cleaning the bag:
the bag and tap it gently to remove dust. On oc-
casion, slip the bag off of the frame and turn
a soft brush.
4. A workshop dust extraction system or a house-
hold vacuum cleaner can be connected to the
dust and shavings permitting a safer and clean-
er working environment.

DRIVE BELT REPLACEMENT

CAUTION: Always ensure that the tool
is switched off and unplugged from the power
supply before making adjustments or installing
or removing blades..
1. To replace the drive belt first take out the four
cross-head screws that secure the drive belt
cover on the left-hand side of the planer as
viewed from the rear (Fig. 17).
2. Remove the damaged belt and use a soft brush
to clean the pulleys and the surrounding area.
-
-
-
-
-
7
EN