After Finishing Work; Transporting; Transporting The Chainsaw; Transporting The Battery - Stihl MSA 220 C Notice D'emploi

12 After Finishing Work

► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at
the same height as the felling cut and use it as
a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.
12 After Finishing Work
12.1 After Finishing Work
► Switch off the chain saw, engage the chain
brake and remove the battery.
► If the saw is wet: Allow the saw to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the saw.
► Clean the bar and chain.
► Loosen the wingnut.
► Rotate the adjusting wheel two full turns coun‐
terclockwise.
The chain is now slack.
► Tighten down the wingnut.
► Fit the scabbard so that it completely covers
the guide bar.
► Clean the battery.

13 Transporting

13.1

Transporting the Chainsaw

► switch off chain saw, engage chain brake and
remove battery
► Fit the chain scabbard so that it completely
covers the guide bar.
Carrying the chainsaw
► Carry the chainsaw by holding the front handle
in your right hand with the guide bar pointing
to the rear.
0458-795-9621-B
Carrying the chainsaw in a vehicle
► Secure the saw to prevent turnover and move‐
ment.
13.2

Transporting the Battery

► Switch off the chain saw, engage the chain
brake and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the
battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the
packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the
transport of dangerous goods. The battery is
classified as UN 3480 (lithium-ion batteries) and
has been tested in accordance with UN Manual
of Tests and Criteria, Part III, sub-section 38.3.
For transport regulations see www.stihl.com/
safety-data-sheets

14 Storing

14.1

Storing the Chainsaw

► Switch off the chainsaw, engage the chain
brake and remove the battery.
► Fit the scabbard so that it completely covers
the guide bar.
► Observe the following points when storing the
saw:
– Saw is out of the reach of children.
– The saw is clean and dry.
► If you store the saw for more than 3 months:
Remove the bar and chain.
14.2

Storing the Battery

STIHL recommends that you store the battery
with a charge between 40% and 60% (2 LEDs
glow green).
► Observe the following points when storing the
battery:
– Battery is out of the reach of children.
– Battery is clean and dry.
– Battery is in an enclosed space.
– Store the battery separately from the saw
and charger.
– Battery is in non-conductive packaging.
– Battery is in a temperature range between
-10°C and +50°C.
English
49