Starting Up - switel DC60 Série Mode D'emploi

2

Starting Up

Safety note
Caution: It is essential to read the Safety Information in
Chapter 1 before preparing the telephone for use.
Check the contents of the package
The package contains:
Content
a B e s u t i n
Charger unit
Cordless handset
Battery cover
Power adapter plug
Telephone connection cable
AAA 1.2V 800mAh NiMH
rechargeable batteries
Operating manual
Connecting the base unit
Connect the base station as illustrated in the diagram.
For reasons of safety, only use the power adaptor plug and telephone
connection cable supplied.
DC601 DC602 DC603 DC604
1 1 1
0 1 2
1 2 3
1 2 3
1 2 3
1 1 1
2 4 6
1 1 1
Inserting the batteries
Insert the 2 x AAA 1.2V 800mAh NiMH rechargeable batteries supplied,
into the handset battery compartment. Take care to note the '+' and '-'
markings and position the batteries the correct way around. Close the
battery compartment cover.
1
Charging the batteries
3
Place the handset in the base to charge for a minimum of 15
4
hours before fi rst use.
4
Private branch exchanges
The information on Page 77 explains how to install your
4
telephone on a private branch exchange.
1
Low-radiation operation (ECO mode)
8
In Standby mode, the radiation is reduced considerably as compared to
standard, cordless DECT telephones when the handset is on the cradle.
1
Electrical consumption
The electrical consumption of the base is:
- in operation mode (idle/call): approx. 0.87 W/1.36 W
- during charging of the handset: approx. 2.15 W.
The adaptor input power without load is approx. 0.20 W.
The average efficiency is approx. 67.3 %.
The electrical consumption of the charger is:
- without handset charging: approx. 0.32 W
- during charging of the handset: approx. 1.7 W.
The adaptor input power without load is approx. 0.32 W.
The average efficiency is approx. 44 %.
Starting Up
GB
65