Programming The Speed Controller; Programming Of Neutral And Full Throttle Positions - Reely ROAD 1:10 EP Onroad-Car Audi S5 4WD BL RtR Notice D'emploi

Table des Matières

Les langues disponibles



10.

Programming the Speed Controller

a) Programming of Neutral and Full Throttle Positions

A On/off switch

B Setup button

C Red LED

D Orange LED

For programming the neutral and full throttle positions for forward/reverse driving, proceed as follows:

• Place the vehicle on an appropriate surface so that the wheels can turn freely.

• Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the trimming for driving into the

centre position. Put the reverse switch for driving into the "Reverse" position.

• Keep the setup button (B) down and switch the speed controller on with the on/off switch (A); switch position "ON",

see figure on top. Press and hold the setup button (B) until only the orange LED is lit (about 4 seconds). Then

release the setup button (B).

• Move the throttle/brake lever into full throttle for forward driving (pull the throttle all the way towards the handle) and

keep it there.

The red LED (C) flashes for about 2-3 seconds and then is lit permanently. The motor emits a sound signal (it is

generated by the brief activation of the motor by the speed controller). The full throttle position for forward driving is

stored.

• Move the throttle/brake lever into full throttle for reverse driving (push the throttle away from the handle all the way)

and keep it there.

The orange LED (D)flashes for 2-3 seconds and then is lit permanently. The motor emits two sound signals. The full

throttle position for reverse driving is stored.

• Release the throttle/brake so that it sits in the neutral position.

The red LED (C) and the orange LED (D) flash at the same time for about 2-3 seconds and go out then. The motor

emits three sound signals. The neutral position is now saved.

• Switch the speed controller off; the programming is complete and stored now.

• If you switch on the speed controller again now, the speed controller is ready for operation with the settings made

above.

OFF ON

Table des Matières

Table des Matières

23 91 02