21_5.Inspection Of The Parts; Dismantling The Cabinet - Specialized Technician - Arneg Panama 2 Manuel D'installation

surfaces due to the abrasive cleaning method.
All the cleaning operations, including the disinfection, the rinse and the drying
must be performed diligently, eliminating any water or detergent residue so as
to avoid the spread of bacteria harmful to health.
Parts left to dry with detergent or disinfectant residues may get damaged.
Remove any element from the pavement such as: sponges, rags, detergent or
water residues that may cause accidental slipping and falls.

21_5.Inspection of the parts

Once you've finished the cleaning, disinfection, rinse, and drying operations,
accurately check that all the parts are perfectly clean and dry and that they are not
damaged or excessively worn out and, if need be, replace them.
Reassemble the completely dry elements and restore electrical power supply. Once
the internal operating temperature has been reached, it is possible to load the products
to be displayed in the cabinet.

22.Dismantling the cabinet - specialized technician -

The cabinet must be dismantled in compliance to the norms that concern the handling
of wastes foreseen in the individual countries, and in respect of the environment in
which we live in. This product is considered by the Legislature in force to be a
dangerous waste and therefore its separate waste collection is obligatory and it cannot
be treated as domestic waste nor assigned to a waste dump. Before dismantling the
cabinet, it is necessary to provide for the recovery of the refrigerant and to remove the
lubricant oil. This product is made up by 75% of recyclable materials. Materials used in
the manufacture:
- Varnished steel:
- Copper, Aluminum:
- Galvanized steel sheet:
- Expanded polyurethane (R134a):thermal insulation
- Tempered glass:
- Wood:
- PVC
- Polystyrene
- Polycarbonate
It is the user's responsibility to deliver the product intended to be dismantled to
the collection center specified by the local Authority or indicated by the
Manufacturer to recover and recycle the materials.
All these operations as also transport and waste treatment must be exclusively
performed by specialized and authorized personnel.
05060117 00 06/05/2011
risers, shelves, feet
refrigeration circuit, electrical system and upper
overhead lights
lower panels, varnished panels, base structure, decks,
trays
crystal sides
foamed tank side frames
Bumper pads and hand rails
Thermally molded shoulders
fluorescent lamps protection
Panama 2
English
37