Clean The Doors; Inspect The Parts; Load The Refrigerant - Arneg Laval 4 Manuel D'installation Et De Service

23.9 Clean the doors

Step
1
2
3 clean as indicated for the glass parts (chapter 25.5)
4 reinstall the closures
23.10

Inspect the parts

Step
1 check that all parts are perfectly clean and dry
2 check that they are not damaged or too worn
3
4 install the parts perfectly dry
5 restore electrical power supply
24.
BEFORE ANY OPERATION EMPTY THE ENTIRE SYSTEM!
Only specialist technicians may recharge the refrigerant or work on the gas circuit accord-
Check that refrigerant circuit is perfectly sealed.
Only use original spare parts.
i
for the type and mass of the refrigerant refer to the serial plate
Procedure
05060210 00 05-2021
Step
1
2
3 remove the cause of the leak
4
5
6 load through the special valve provided next to the compressor
Laval 4 - Gander 4 - Rodi 4
•
English
-
45