Cleaning Products; General Information; Cleaning Of The Outer Parts (Daily / Weekly); Clean The Internal Parts (Monthly) - Arneg Santiago 2 Manuel D'installation Et De Service

Santi ago 2
English

22. 1 Cleaning products

- clean water at maximum temperature of 30°C
Use
- soft cloth
- mild and neutral detergents
- detergents or similar products to clean the parts in methacrylate (Plexiglas)
Do not use
- in powder
alcohol-based
- with granules
- either acidic or alkaline (bleach, ammonia)
- concentrates
- with unknown chemical compositi on
- abrasive products, chemical/organic solvents
- abrasive sponges, scourers, sharp tools
- aggressive solvents (aceti c acid, citric acid etc.)
22. 2 General informati on
• The surfaces to be cleaned and the detergents and water used for cleaning must not exceed a
maximum temperature of 30°C.
• Dry thoroughly with a soft cloth
ATTENTION!
Fragile surfaces, glass. Dents, scratches, corrosion, wounds, broken glass
DO NOT aim the jet directly at the varnished or plasti cised surfaces
DO NOT apply the detergents directly onto the surfaces to be cleaned
DO NOT use steam cleaning equipment
DO NOT use excessive force
DO NOT bring the jet too close to the dirt. This may cause injury to the operator and con-
taminate parts that have already been cleaned, as well as the environment.
avoid detergents from coming into contact with nearby products.
ATTENTION!
Floor products. Vapours. Corrosion. Breathing diffi culty.
avoid contact, inhalati on.

22. 3 Cleaning of the outer parts (Daily / Weekly)

Clean all external parts of the cabinet every week. See "General instructi ons" chapter 22. 2.

22. 4 Clean the internal parts (Monthly)

Refer to chapters 22. 1 and 22. 2 and proceed as follows:
Step
1 remove all foodstuff from the cabinet
2 remove all the removable parts, such as display dishes, grid trays, etc.
3 wash with lukewarm water (max 30°C)
4 disinfect using an anti bacterial detergent
carefully clean the bott om tank, the drip and the grid that protects the water drain, eliminat-
5
ing all foreign bodies that have fallen through the sucti on grid lift ing the sheet of the fans
6 carefully dry using a soft cloth
i
Should you noti ce ice built up, call a specialized technician.

22. 5 Clean the honeycomb (every 6-8 months)

Step
1 remove the screw that secures the honeycomb support (Fig.24)
2 remove the honeycomb
3 follow the steps given in chapters 22. 1 and 22. 2
4 reassemble the honeycomb completely dry, at the same angle
48
Acti on
Acti on
05060185 00 19-06-2019