Arneg Panama 2 Manuel D'installation page 126

protective tools and clothing required under the safety regulations or laws in effect in
the country where it is installed is recommended. In any case, always use appropriate
equipment and clothing, such as: safety shoes, protective gloves, a level.
For installation, please proceed as follows:
carefully inspect the installation area, removing any danger(s) to the operator;
Do not position the cabinet:
in environments with the presence of explosive gaseous substances;
outdoors and therefore where there are atmospheric agents;
near heat sources (in direct sunlight, near heating systems, incandescent lights,
etc.)
near air currents (near doors, windows, air-conditioning/heating systems, etc.)
exceeding speeds of 0.2 m/sec.
Remove the wooden supports on the base (used for transportation) and attach the
adjustable feet (Rif. 5) positioning them so that the unit is horizontal, using a level (Rif.
6) to check the alignment.
Before connecting the unit to the electricity, ensure that the plate data corresponds to
the characteristics of the electrical system to which it is to be connected.
For the unit to function properly, the temperature and relative humidity must not exceed
the limits for climate class 3 (+25°C; R.H. 60%) as established in EN-ISO 23953 - 2
regulations, under which the unit was tested
Multiplex up to 3 cabinets on the same electrical and refrigeration
supply line (1 master + 2 slaves)
If the unit is moved, repeat the levelling process, as improper levelling
could compromise the unit's operations.
The unit must be levelled both in the front and in the back.
11.Multiplexing cabinets - specialised technician -
Before multiplexing the units make sure that they are level.
To multiplex two or more units, proceed as follows:
Disassemble the sides (if present).
Position the cabinets side by side
Remove the back panels to gain access to the rise holes
Join the rises and brackets using the screws supplied
Replace the back panels.
Check that the aligning plugs are inserted in the appropriate housings.
Multiplex kit
Pos.
1 Handrail alignment pin
2 Handrail alignment pin
3 TCEI M8X80 screw
4 TCEI M8X120 screw
5 TCEI M6x25 screw
6 Nut M8
7 Nut M6
8 Washer
05060133 00 23/07/2012
Name
.
Code Items
02940652 3
02047000 3
04711030 1
04711065 5
04711098 1
04230600 8
04230000 1
04480112 6
Panama 2 H125-150
English
31