Lighting; Replacing Bulbs (Rif. 25); Night Cover - Optional - (Rif. 29) - Arneg Panama 2 Manuel D'installation

Panama 2 H125-150
English
This will prevent unpleasant odours from forming within the unit, the dispersion of
refrigerated air and possible unit malfunctioning due to humidity.
Periodically check that the hydraulic connections are still efficient, contacting a
qualified installer.

17.Lighting

Internal lighting of the unit is obtained through fluorescent OSRAM type lights. The light
For greater energy savings, the cabinet can be ordered complete with low
consumption LED lighting. This allows for:
reduced lighting consumption
reduced refrigerator load
lighting lifespan: over 6 years
uniform light intensity and colour
improved lighting as temperature decreases.
switch is beside the light fixture (Rif. 7).
If the shelving positions are changed, the power supply sockets no longer
used must be closed with the caps supplied with the unit (Rif. 18)
DO NOT leave the sockets uncovered. Risk of electrocution.

18.Replacing bulbs (Rif. 25)

Replace the bulbs as follows:
Turn off the unit's power supply.
Remove the methacrylate guard 1, slide the bulb out from the housing 2, and
replace it with an identical new bulb.
Reinsert the light, making sure that the contacts are correctly placed in the
appropriate openings.
Reattach the methacrylate guard.
Restore the electricity supply.

19.Night cover - optional - (Rif. 29)

To avoid pointless dispersion of the cold and to guarantee the hygiene of the goods
supplied during the night, manual night shades are available as optional extras.
Instructions for assembling manual night shades.
Assembling the two night shade models (Mod.1-Mod.2) is the same:
Attach the shade supports 1 (A).
Load the spring by turning the flat pin 7 clockwise, holding the shade steady so that
the triangle on the cap of the pipe stops at the top (with the point down) (B).
Insert the flat pin into the shade support. If you want to use the automatic stop so
that the shade stops at every turn, the flat pin must be inserted in the position with
"UP" at the top (B) If the shade is mounted in a different position, the automatic
stop is off.
Position the shade fastener 3 on the pin, insert it into the shade support, and turn it
90° (C).
Approximate table for loading spring units
Width manual shades
Preloading recommended (with cloth wound up)
Max spring load (with cloth unwound completely)
Remove the stop-lever 9, if present, before use
34
< 1250 mm >1250
20 - 30 25 - 30
50 55
05060133 00 23/07/2012