STERWINS 40VCS2-34.1 Notice De Montage, D'utilisation Et D'entretien page 345

7.2 STORE THE LITHIUM BATTERIES
Please make sure that the battery power level is as recommended in the battery instruction manual.
Please refer to the battery instruction manual for further details.
8. MAINTENANCE
DANGER! Risk of injury due to electric shock.
Remove the battery pack and make sure that all moving parts
have come to a complete stop before adjusting, inspecting,
cleaning or storing the product.
8.1 CLEANING
Illustration 5.2 to 5.8
Keep all safety devices, air vents, and motor housing free of debris and dirt. Wipe down the equipment
with a cloth and/or compressed air. It is highly suggested that you clean the product after every use.
Do not use cleaning agents, as these can attack the plastic and weaken the structural integrity of the
chain saw.
Remove and brush clean the cover plate, chain and chain bar after 1 to 3 hours of use.
Clean the area under the cover plate, the drive sprocket and chain bar assembly using a soft brush.
Clean oil outlet with a clean cloth.
Do not place other objects on the chain saw.
8.2 REPLACEMENT
Illustration 5.1
WARNING! When handling saw chains, always wear protective
gloves.
Checking the automatic chain lubrication
Regularly check the functionality of the automatic chain lubrication in order to prevent overheating and
the subsequent damage to the chain bar and saw chain associated with it. For this purpose, align the
chain bar tip against a smooth surface (board, cut-in of a tree) and allow the chain saw to run. If an
increasing amount of oil appears, the automatic chain lubrication functions properly.
Lubricate sprocket
NOTE : It is not necessary to remove the chain or bar when lubricating the sprocket.
1. Clean the bar and sprocket.
2. Using a grease gun, insert the tip of the gun into the lubrication hole and inject grease until it appears
at the outside edge of the sprocket tip.
3. To rotate the sprocket release the chain stop and pull the chain by hand until the ungreased side of the
sprocket is in line with the grease hole. Repeat the lubrication procedure.
Sharpening the saw chain
Keep chain sharp. Your saw will cut faster and more safely. A dull chain will cause undue sprocket, guide
bar, chain, and motor wear. If you must force chain into wood and cutting creates only sawdust with
a few large chips, then chain is dull. Purchase a new chain, have your chain sharpened professionally
at a qualified service center, or sharpen the chain yourself using a proper sharpening kit. The height
difference between the cutting tip and the ridge is the depth gauge setting. When you sharpen the
345
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN