First Use - STERWINS 40VCS2-34.1 Notice De Montage, D'utilisation Et D'entretien

- Helmet with visor and neck guard
- Hearing protectors
- Breathing mask
- Gloves with approved saw protection
- Protective leggings with approved saw protection
- Steel toe cap boots with approved saw protection
- First aid kit in case of injury.
Filling the auto oil system : illustration 3.3
CAUTION ! The chain saw is NOT supplied filled with oil. It is essential to fill with oil before use.Never
operate the chain saw without chain oil or at an empty oil tank level, as this will result in extensive
damage to the product. Chain life and cutting capacity depends on optimum lubrication. Therefore, the
chain is automatically oiled during operation via the oil outlet.
This chain saw features an auto-oiling system to keep the chain and guide bar properly lubricated. The oil
level indicator shows the remaining oil in the chainsaw.
If the oil level decreases to below one quarter capacity, refill it with the proper bar and chain oil. To fill
the oil reservoir:
1. Remove the oil cap. Fill the reservoir with bar and chain oil until the oil level has reached full capacity.
2. Put the oil cap back on. Make sure to check the oil level after every 10 minutes of use. Unplug the chain
saw before checking oil levels or filling the oil reservoir.
CAUTION ! To prevent oil leakage, ensure machine is left in a
horizontal position (oil filler cap upright) when not in use.
Use only the recommended oil to avoid damage to the chain
saw. Never use recycled/old oil.

4.4 FIRST USE

Check the battery
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
The battery is not fully charged at the time of purchase.
Before using the product for the first time, place the battery
in the charger and charge it fully.
Pay particular attention using the machine for the first time : focus and dedicate all your attention to this
first use. Make the first trial on a free space with no obstacle and no surrounding element
4.5 OPERATION
Switching on/off : illustration 4.2
To turn the tool ON, push and hold the safety lock-off button with your thumb, while squeezing the
ON/OFF trigger switch. Once the trigger switch engages, you can release the safety lock-off button and
proceed with operation. The safety lock-off button reduces the risk of accidental starting.
To turn the tool OFF, release the ON/OFF trigger switch.
339
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN