STERWINS 40VCS2-34.1 Notice De Montage, D'utilisation Et D'entretien page 337

4.1 UNBOXING
2
1
1.ON/OFF trigger switch
2.Safety lock-off button
3.Battery (not included)
4.Front handle
5.Hand guard/chain brake
6.Oil cap
7.Guide bar
• Wear gloves when unboxing.
• Do not use cutter, knife, saw or any other similar tool for unboxing.
• Carry the tool only by the handle pls check.
• Keep the box for further reuse (transport and storage).
• Keep instruction manual in a dry area for further consultation.
4.2 INSTALLATION
Installing/Removing the battery pack : illustration 3.4
WARNING : Make sure the latch on the bottom of the battery pack snaps in place and the battery pack is
fully seated and secure in the product's battery docking port before beginning operation.
Failure to securely seat the battery pack could cause the battery pack to fall out, resulting in serious
personal injury.
To install : To attach, align and slide the battery pack onto the slots of the battery docking port until it
locks in place.
To remove : To release, press the battery unlock button and remove the battery pack from the product.
Assemble the guide bar and the saw chain : illustration 2.1 to 2.5
1. Place the saw body on a firm and level surface.
2. Rotate the locking knob anticlockwise to remove the cover from the saw's body.
4
11
3
12 10 9
337
5
6
7
8
13
8.Chain
9.Locking knob
10.Side cover
11.Battery unlock button
12. Chain tension wheel
13.Blade sheath
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN