STERWINS 40VCS2-34.1 Notice De Montage, D'utilisation Et D'entretien page 341

• Walk, never run. Keep all parts of your body away from any moving part.
• Never run the product without the proper equipment attached.
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
If the product is dropped, suffers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
Basic operating/cutting procedure : illustration 4.1 to 4.5
WARNING: Chainsaws by their very nature are extremely
dangerous machines and should be handled with respect!
We strongly recommend that before use of this product, you attend a
chainsaw training course to familiarise yourself with the maintenance
and usage of these products! Thoroughly read this manual and adhere
to all safety instructions at all times. The manufacturer will not be
held liable for any accidents/injuries caused due to misuse or incorrect
maintenance of this product!
1. To become proficient, attend a recognised chainsaw training course to learn how to operate chainsaws
safely and effectively. Familiarise yourself with all the controls and switches. Practice all movements with
the product switched off.
2. Always hold the product firmly with both hands; front handle with the left hand and rear handle with
the right hand. Fully grip both handles at all times during operation. Never operate the product using
only one hand.
3. Only use the product with a secure stance. Hold the product at the right-hand side of your body.
NOTE : Any other cutting positions should not be used with this product except the chainsaw.
4.Check the lubrication.
Start the tool and check whether the chain can give off a spray of oil within a few seconds. If an oil trace
can be seen, the chainsaw is lubricating.
5.Ensure the saw chain is running at full speed before it makes contact with the wood. Use spiked bumper
to secure the product onto the wood before starting to cut and use it as a leverage point while cutting.
6. Reset the spiked bumper at a low point when cutting thicker logs by pulling the product slightly
backwards, until the gripping teeth release and re-position at lower level to continue sawing. Do not
remove the product completely from the wood.
341
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN