Brill Evolution LION 36 Traduction Du Mode D'emploi Original page 29

Fault
Abnormal sounds
Rattling on mower
Rough running, strong vibra-
tion of mower
Lawn turns yellow,
Unclean cut
Mower leaves deep tracks
Motor does not start
Motor does not start, red LED
flashes
Cutting equipment does not
turn, motor fails. Electronic sys-
tem disconnects due to overload,
red LED flashes.
Battery runtime drops noticeably Cutting height too low
Battery cannot be charged
Possible cause
Loose screws on cutting equipment
or mower housing
Damaged cutting equipment
(unbalance), cutting equipment on
motor shaft has become loose
Blunt cutting blade,
Cutting height too low
Rain-soaked ground, lawn too wet
Missing battery
Faulty battery
Battery not charged
Circuit breaker not connected when
starting mower
Blockage caused by foreign object
or clippings
Cutting height too low
Grass too high or too wet
Mowing speed too high
Mowing with full grass catcher
Battery is empty
Contaminated charging plug or
contact socket
Defective battery / charger
Troubleshooting
Retighten screws
Retighten screws for cutting equip-
ment. Contact manufacturer's custo-
mer service to replace damaged parts
Replace cutting equipment,
Increase cutting height
Install cutting equipment correctly
(see chapter "Replacement of cutting
equipment")
Allow lawn to dry, do not cut wet grass
Check battery / insert battery
Replace battery
Charge battery
Connect circuit breaker
Switch off mower. Disconnect circuit
breaker and remove foreign object.
Ensure that cutting equipment turns
freely. Remove clippings from circular
path of cutting equipment, as well as
from discharge chute.
Empty grass catcher
Increase cutting height
Increase cutting height,
Allow for grass to dry
Decrease speed
Ensure that cutting equipment turns
freely. Remove clippings from circular
path of cutting equipment, as well as
from discharge chute.
Grass catcher might be full. Clippings
fall back into circular path of the cut-
ting equipment.
Replace battery. Use only original
accessories from manufacturer.
Clean contacts, plug and unplug char-
ging plug or contact socket several
times
Replace battery / charger Use only
original accessories from manufacturer
29