Lock guide handle 1 in desired lock position 5 by
D
hand-tightening the two clamping levers 7 on both
sides.
Ensure that the teeth engage properly.
Inserting battery
Caution, risk of injury from rotat-
ing and sharp cutting equipment!
STOP
E
G
Figurers
–
Open battery cover 17. To do so, slightly press 1 x
E
on cover (see illustration).
Ensure that contact plug20 is dry and free from any
contamination. When inserting the battery 19 do
not use force.
Push battery 19 with slight pressure to stop in bat-
F
tery compartment 18. Contact socket of battery
must be firmly positioned in contact plug20 of
mower.
Close battery cover 17. When battery is in correct
G
position, cover must be easy to close. Battery cover
17 locks into position with a "click".
Setting of cutting height
Caution, risk of injury from rotating cutting
equipment! Set cutting height only when motor
is switched off. Set cutting height only low
enough for cutting equipment not to touch any
uneven ground.
Place mower on solid, flat surface.
H
Figure
With cutting height adjustment 15 , seven settings are
possible.
To set cutting height, slightly lift the mower with the
H
handle 10. Pull cutting height adjustment 15 from
lock position, move cutting height adjustment 15 into
desired position and reengage.
For easy operation, cutting height adjustment 15
is spring-loaded.
The scale on cutting height adjustment 15 indicates
approximate cutting height:
Level 1*
= 1,6 cm
Level 2
= 2,5 cm
Level 3
= 3 cm
Level 4
= 4 cm
Level 5
= 5 cm
Level 6
= 6 cm
Level 7
= 7 cm
This position is only suitable for decorative lawns and
*
particularly level areas.
Start-up
For your safety
It is essential that you also follow the "General safety
instructions" as well as the "Safety instructions for
operation of mower" in chapter "Important safety
instructions".
Caution, mower protection!
max. 45 °C
Ensure that grass catcher 9 is in place.
When mowing, always wear suitable work
clothes, such as sturdy shoes, long pants and
possibly gloves. Never mow while barefoot or
wearing thin sandals.
Switching mower on / off
I
Switch on: Figure
Connect circuit breaker 12. In doing so, mower
I
should be on level ground, with all 4 wheels touch-
ing the ground.
To start, push safety release button 3 and with other
hand pull safety start lever 2 against guide handle
1. After motor starts running, let go of safety release
button 3.
Motor starts running with a soft start. Should it be
difficult to start motor, release safety start lever 2.
Reason for this could be that grass around mower
is too high. If this is the case,tilt mower downward
via rear wheels (guide handle 1), though only as
much as absolutely necessary. Restart motor.
Should it still be difficult to start motor, or should
it lock, please see information in chapters "How
to mow your lawn correctly" or "Trou-
bleshooting".
25