J
Switch off: Figures
To switch off motor, release safety start lever 2. Due to
an integrated brake, cutting equipment 21 comes to a
stop within just a few seconds.
Caution, risk of injury from rotating cutting
equipment! In spite of integrated brake, cutting
equipment continues to rotate after motor is
switched off. Stay away from cutting equipment
until motor has come to a full stop.
Caution, mower protection! Do not recharge
battery if it has exceeded max. operating
temperature, or has been exposed to direct sun-
light; this can destroy the battery.
If the mower will not be used again immediately,
J
disconnect circuit breaker 12.
The mower is in standby mode even when circuit
K
breaker has been disconnected. To prevent battery
discharge, remove battery from mower when not in
use for a prolonged time. To do so, open battery
cover 17 and pull out battery.
Status indicator [3 x green / 1 x red]
The mower is equipped with a status indicator that
shows the charge state of the battery, as well as a mal-
function of the mower. The status indicator consists of a
charge status indicator 13 [3 x LED green], as well as
fault indicator 14 [1 x LED red].
As soon as you switch mower on a self-test is per-
formed; in the process, all LED briefly light up for
approx. 1 s. Next, the charge status is shown by
the charge status indicator 13.
Charge statuses (green LED):
26
K
–
3 x LED green continuous
light
Charge status: approx. 100 - 60 %
2 x LED green continuous
light
Charge status: approx. 60 - 20 %
1 x LED green continuous
light
Charge status: < 20 %
1 x LED green flashing
light
Charge status: Battery empty
BATTERY MUST BE
CHARGED!
Indicator states (red LED):
Caution, mower protection! Red continuous
light! In case of overload, electronics switches
mower off, red LED is on. Release safety start lever
and disconnect circuit breaker. Search for cause
before performing restart and resuming work
with mower. For additional information, see
chapter "How to mow your lawn correctly" or
"Troubleshooting". If the red LED stays on dur-
ing a restart, an immediate inspection is required,
possibly by manufacturer's customer service.
Grass catcher
Handling of grass catcher
The mower is equipped with a filling indicator 6. As soon
as filling indicator 6 shows FULL, or clippings remain on
the lawn during mowing, the grass catcher 9 is full and
must be emptied.
Caution, risk of injury from rotating cutting
equipment! Remove grass catcher 9 only when
motor is switched off. In spite of integrated brake,
cutting equipment continues to rotate after
motor is switched off. Stay away from grass catch-
er until motor has come to a full stop.
L
O
Figures
–
To remove grass catcher 9, open both box locks 8.
L
Fold multi-function box 4 backward and hold it.
M
Lift grass catcher 9 in front at the handle area, so
N
that clippings remain in grass catcher9. Empty grass
catcher 9.
After emptying, fold multi-function box 4 back
O
again. Next, insert grass catcher 9 first in the back
between the right and left guides, then in front in
the handle area. If grass catcher 9 is inserted cor-
rectly, the multi-function box 4 folds forward and
fits against the housing. Close both box locks 8.
LED red continuous light
Overload or malfunction
LED red flashing light
Circuit breaker is not con-
nected during switching on .
Motor does not start.