User's Guide - Dantherm CDT 22 Manuel D'entretien

User's guide

Introduction
Start/stop without
hygrostat
Start/stop with
hygrostat
26
This chapter gives all relevant information about the use of the dehumidifier, including:
• Start/stop without hygrostat
• Start/stop with hygrostat
• Start/stop with heating element (CDT 35S)
• Emptying the water container
Follow this procedure for start/stop of the dehumidifier in continuous operation
independently of the relative humidity in the room:
Where is the main switch placed: See "Product and functional description" page 21
under Illustration, hygrostat connection.
Step
Start Set the main switch in pos.
Fan and compressor will start.
The light of the main switch turns on
Stop/disconnect Turn the main switch to pos.
Set the main switch in pos.
compressor will stop. The light in the main
switch turns off
Follow this procedure to start/stop the dehumidifier by the hygrostat:
Step
1 Connect the hygrostat as described in "Product and functional
description" page 21
2 Set the main switch in pos.
will start. The light of the main switch turns on.
The dehumidifier will now work as described below
and start/stop automatically according to the humidity
of the room air.
Value
The unit starts to
dehumidify
The dehumidifier
stops
If the dehumidifier is to be turned off completely,(for example if the
water container is to be emptied), then stop the dehumidifier as
described above. ("Start/stop without hygrostat")
Action
. Fan and
Action
. Fan and compressor
Action
if the relative humidity of the room is higher
than the hygrostat setting
the room air humidity is lower than the set
value, but the light of the main switch is still
on
Main switch
Main switch
Continued overleaf