Dantherm CDT 22 Manuel D'entretien page 27

User's guide,
continued
Start/stop with Only CDT 35S!
heating element
Follow this procedure to start/stop the heating element, which after deactivating works
continuously independently of the relative humidity of the room:
Emptying the Follow this procedure to empty the water container: (CDT 85 does not have a water
water container container)
Step
Step
1 Set the main switch on
start. The light of the main switch is now on
2 Start the heating element by activating its switch.
Result: The light of the switch turns on.
The heating element can be turned off by pressing
the switch again
1 Switch off the unit before taking out the water container
2 Remove the water container by pressing inwards to disengage the cut of the
water container from the edge
3 Empty the container
4 Reinsert the water container.
Important:
When reinserting the water container
take care not to place the container in a
position which switches off the
automatic water stop function
If the water stop function does not work,
the water in the container will run over.
Action
. Fan and compressor will
Action
correct placing of the
Main switch
Fig. 22 -
water container
27