Installation, Operating and Maintenance
Instructions panicLock 179
3
Installation
1) The selection, combination and installation of the lock, lock plates, profile cylinder
and furniture set for FS sets (spindle size 9 mm) have to be performed according to
the technical documents of the (individual) manufacturer.
NOTE!
See Planning Manual Winkhaus „Product range door locking systems" for lock and
lock plates. Selection of door handle set for the manufacturer of DO numbers see
appendix 5!
DANGER! IMPORTANT ADVICE! ABSOLUTELY VITAL TO READ THIS!
Antipanic door locks and Emergency door locks can block if not fitted with the correct
cylinder. In this case the escape door can not be opened and/or the emergency lock
can be destroyed.
Always remove the key from the lock to avoid blocking the emergency locking me-
chanism!
To avoid a blockage in an antipanic door lock, they must be fitted only with profile
cylinders, which are designed especially for use in antipanic doors, e.g. so-called free
to turn cylinder for transmission lock (german FZG).
Therefore the profile cylinder must have a free to turn function, for example Wink-
haus cylinder in specification .../15 (e.g. double cylinder DZ 01/15, DZ 06/15; half
cylinder HZ 02/15) with anti blockade function.
Especially with electronic cylinders has to be due to an increased drag effect to a se-
cure case default!
Furthermore the bit position has to be max. ± 30°.
In case of any doubt contact your cylinder supplier or manufacturer!
NOTE!
Exception: For panicLock AP 179 AV3 OR it is possible to use a cylinder without free
to turn function.
2) The locking system is only suited for the installation of a door furniture set with
alternate function (e.g. fixed knob outside/handle inside)
Aug. Winkhaus GmbH & Co. KG · Berkeser Str. 6 · D-98617 Meiningen
Subject to technical changes
7
Print-no. 504 474 2
09/2016
Important
Information
Product
Description
Installation
Maintenance
and Care
Appendix
www.winkhaus.de
EN
1
2
3
4
5