Use As A Handheld Steam Cleaner - Cleanmaxx JJ-SC-005B Mode D'emploi

6. Insert the mains plug in a properly installed socket that is easily accessible. The power LEDs (12)
behind the water tank will illuminate in red as soon as operating voltage is present. Wait until
the appliance has reached the operating temperature and the power LEDs are blue.
7. Now you can start to clean the fl oor. Push the
unit. (The switch on the back (13) has been deactivated when the handle bar is inserted.) Steam
will begin to be emitted from the cleaning head. You can now increase the quantity of steam by
turning the knob for the steam quantity control.
NOTE: After the knob is turned, it will take a few seconds until the respective steam quantity
is reached.
8. Hold the appliance by the handle and tip it slightly towards the fl oor in order to release it from
the upright locking position.
9. Slowly slide the cleaning head back and forth over the fl oor. The fl oor will be cleaned in the
process.
10. When the power LEDs blink red, there is too little water in the tank. Push the
switch before you fi ll the tank. Before you wash out the fl oor pad or once you have fi nished
cleaning the fl oor, push the
pull on the cord, but always on the plug.
11. Wait a few minutes for the appliance to cool off before you remove the fl oor pad. Be aware
that when turning off the appliance a wet area can form beneath the cleaning head.
12. Follow the instructions in the section "After use".

Use as a handheld steam cleaner

ATTENTION!
❐ Risk of injury! Only hold the appliance by the handle during operation.
❐ Always work with suffi cient lighting.
❐ Never attempt to smooth clothing when it is being worn by someone.
❐ When smoothing fabrics, always test the appliance on a small, unnoticeable area fi rst. Make
sure that there is enough space around the piece of clothing you intend to smooth. For this,
it must be hanging on a clothes hanger and may not come into contact with other pieces of
clothing, objects, persons or animals.
❐ Only hang up the fabric you intend to smooth where there is no risk of heat or moisture
infl icting damage.
1. Take the handle bar and cleaning head off of the main unit and mount the nozzle adapter with
the desired nozzle on it (see chapter "Assembling the appliance" and "Appliance functions
(Nozzle functions)"). If you would like to steam smooth fabric, the corresponding microfi ber
cloth must be attached to the nozzle with squeegee lip.
2. Fill the water tank (see chapter "Filling the water tank").
4. Turn the knob for the steam quantity control (8) to the minimum
setting by turning it counterclockwise until it comes to a stop.
5. Park the appliance in an upright position. The hinge of the cleaning head
locks in when in an upright position.
On / Off switch and pull the mains plug out of the socket. Never
On / Off switch (4) on the front of the main
26
On / Off