Use; Cleaning The Fl Oor - Cleanmaxx JJ-SC-005B Mode D'emploi

1. Take the water tank out of the appliance to fi ll it. To do so, depress both side release buttons (6).
2. Open the water tank: Turn the water tank lid (5) a bit in a counterclockwise direction and
remove it.

Use

ATTENTION!
❐ Scalding hazard! Never point the steam towards people, animals, plants or equipment containing
electric components (e. g. stereo systems, televisions, switches, lights, microwave appliances
etc.).
❐ Scalding hazard! Only hold the appliance by the handle during operation.
❐ Scalding hazard! After deactivating the appliance, hot steam is emitted for a few seconds! Even
after the appliance has cooled off, the water in the tank is still hot! Be careful!
❐ Always shut off the appliance and pull the mains plug out of the socket before you remove the
fl oor pad or change the nozzle.
❐ ATTENTION! Scalding hazard! The fl oor pad / nozzle may be very hot during and shortly after
use. For this reason, wait a few minutes for the cloth / nozzle to cool off completely before you
remove it.
❐ ATTENTION! Damage to property! Do not use the device on very cold glass surfaces.
❐ Each time before using the appliance, check the fl oor pad for wear. It may not be used if it is
visibly worn down or is damaged. Otherwise it could damage your fl oor.
❐ Only use the appliance when it is functional and has been completely assembled and the fl oor
pad (when cleaning the fl oor) has been attached.
❐ Never apply the vapour stream to one area for more than approximately 10 seconds.
Otherwise, it could damage the surface.
Cleaning the fl oor
It is recommended that you briefl y sweep the fl oor surface with a broom or vacuum it
before using the appliance.
1. Mount the handle bar with the handle and the cleaning head on the main unit. Attach the fl oor
pad to the cleaning head and, if you would like to clean a carpet, the carpet cleaning head (see
chapter "Assembling the appliance").
2. Fill the water tank (see chapter "Filling the water tank").
3. In order to unwind the power cord, turn the top hook of the cord spool down. Hang the
power cord in the cord holder (3) for better handling of the steam cleaner when cleaning
fl oors and so that you do not trip over the cord.
3. Fill the tank with cold, clean water. You can use the enclosed measuring
cup (K) to do so. The tank holds up to 350 ml.
4. Screw the water tank lid back onto the water tank by turning it in a
clockwise direction and then insert the tank back into the main unit. It
must audibly lock into place.
25