Joerns Oxford Calibre Manuel De L'utilisateur page 8

Oxford
®
Calibre
Disassembly
Disassembly must be carried out by a competent engineer from an authorised Oxford
Service Agent/Dealer.
The lift should not be disassembled unless for service, repair or transport if necessary. Therefore
follow the assembly instructions in reverse sequence.
ALWAYS CHECK THE FOLLOWING BEFORE OPERATION
• The mast is fully locked into position by checking the grub screws at the front and rear of the
base are tight.
• The red emergency stop button, located on the rear of the control box, is in the OFF (out)
position.
8
WARNING
Front grub screw
Rear grub
screw
English