Conrad Electronic MS-9160 Notice D'emploi page 23

AC voltage 40 mA
True RMS = 400 mA
effective value
crest factor 3 4 A
20 A
Frequency of DC voltage:
from 40 Hz to 10 kHz of 40 mA and 400 mA range
from 40 Hz to 1 kHz of 4A and 20 A range
400 Ω
Resistance
4 kΩ
40 kΩ
400 kΩ
4 MΩ
40 MΩ
Capacity 4nF
40nF
400nF
4uF
40uF
400uF
Inductance 40 mH
400 mH
Continuity tester: acoustic signal in case of resistances smaller
than 30 Ohm, measuring tension 2.0 VDC max.
44
±(2.5%+3dgts)
10 uA
±(2.5%+3dgts)
100 uA
±(2%+5dgts)
1 mA
±(2%+5dgts)
10 mA
±(0.5%+1dgt) 0,1 Ω
±(0.5%+1dgt) 1 Ω
±(0.5%+1dgt) 10 Ω
±(0.5%+1dgt) 100 Ω
±(0.5%+1dgt) 1 k Ω
±(1%+2dgts)
10 kΩ
±(2%+3dgts)
1pF
±(2%+3dgts)
10pF
±(2%+3dgts)
100pF
±(3%+5dgts)
1nF
±(3%+5dgts)
10nF
±(3%+5dgts)
100nF
±(3%+20dgts)
10 uH
±(3%+10dgts)
100 uH
6.3 Maximum input levels, overload protection
(Multimeter)
Voltage measurement: 1000 VDC and 750 VAC
Current measurement: 400mA AC/DC in mA range
20 A AC/DC in 20A range, 30 sec. max. duration
with a subsequent cooling phase of at least
15 minutes, 250 VDC/VAC rms max.
Resistance
measurement: 40 MOhm, Overload protection 250 VDC/AC
Continuity test: Overload protection 250 VDC/AC
Logic measurement: Overload protection 250 VDC/AC
Capacity
measurement: 400 uF
Inductance
measurement: 400 mH
Attention!
The capacity and inductance measurement functions are not protected
against overload or excessive input voltage(s). Exceeding the maximum
permitted input will result in damage to the measuring instrument or
can endanger the user's life.
45