Description Of Controls; Engine Brake Lever / Cutting Means; Drive Lever - inventiv INV T6553 TBV Manuel D'utilisation

7. DESCRIPTION OF CONTROLS

7.1 ENGINE BRAKE LEVER / CUTTING MEANS

7.2 DRIVE LEVER (where applicable)
On power-driven models, push the lever (1) toward the
handle for forward movement.
The lawnmower stops moving forward when the lever
is released. The engine must always be ignited with the
drive disengaged.
WARNING! To prevent damage to the transmis-
sion, do not pull the machine backwards with the
transmission engaged.
The cutting means brake is controlled by the lever
(1) which must be held against the handle during
ignition and during lawnmower operations.
The engine stops when the lever is released.
• Type II
Return the handle (1) to the
work position and fasten it to
the side chassis supports as
shown in the diagram, using
the handles (2) and relative
nuts and bolts.
Make sure the pins (2a) are
inserted in one of the two holes
(2b) on the side supports of the
chassis so as to achieve the
correct height of the handle.
The rings (9) on the levers (2)
must be screwed on so that
the distance from the handle is
around 9 mm (when the levers
are released) to ensure secure
fastening without requiring too
much effort to tighten or release
the levers.
• Manual ignition models
Insert the starter cable (6) in
the spiral (7) and tighten the
nut (8)..
• Manual ignition models
Insert the supplied battery in
the relative engine compart-
ment (par. 8.2) .
7 EN