Assembling The Device; Assembling The Frying Basket; Assembling The Fryer; Operation - SilverCrest SEF 2300 C3 Mode D'emploi

7. Assembling the
device
7.1 Assembling the frying
basket
1. Figure C: press the metal brackets on
the handle 17 and put their ends into
the small eyes on the inside of the frying
basket 18.
2. Tilt the handle 17 towards the outside
until it locks in place.

7.2 Assembling the fryer

WARNING! All parts must be dry and un-
damaged.
1. Put the oil container 14 into the hous-
ing 15.
2. Insert the base unit 11 at the designat-
ed place on the housing. Let the rails of
the base unit 11 just slide into the open-
ings on the housing 15.
3. The basket 18 and the handle 17
should only be put into the fryer, when
oil and food have already been filled in
(see "Frying" on page 68).

8. Operation

8.1 Setting up

Fire hazard!
The mains plug 10 should only be put
into the wall socket after the oil contain-
er 14 has been filled with oil or melted
fat at least up to the MIN marking.
• All parts of the fryer must be completely
dry, when you use the device.
• Put the fryer on a stable, flat, non-slip,
dry, and non-inflammable work surface.
• Do not use the fryer under wall units
and not near to any curtains, paper or
any similar inflammable objects.
• Do not place the device directly under a
wall socket.
• Keep a distance of at least 50 cm on all
sides.

8.2 Filling in the frying fat

Fire hazard / DANGER of
burns!
The level of the frying fat/oil in its liquid
state must be between the MAX and
MIN markings on the inside of the oil
container 14.
Only fats and oils which are suitable for
frying should be used (see "The basics
of frying" on page 64).
1. Approx. 3.4 (MIN) to 3.6 (MAX) litres
of frying oil or approx. 3.6 kg of solid
frying fat are required.
2. Solid frying fat should first be put into a
pan and melted slowly at a low temper-
ature. Only then it should be poured
carefully into the oil container 14 of the
fryer.
67
GB