Insert Tools, Accessories; Technical Data - Hilti PD 40 Mode D'emploi

2.13 PDA 71 measuring extension
The measuring extension is made from aluminium and is equipped with a non-conductive synthetic rubber grip. The
screw on the measuring extension should be screwed into the threaded bush on the rear contact surface of the PD
40. When the measuring extension is screwed onto the tool, the rear reference is then relocated to the tip of the
measuring extension, i.e. the rear reference is extended by 1270 mm (50 inches).

3 Insert tools, accessories

Designation
Target plate
Target plate
Target plate
Measuring extension
Designation
Hand strap
Soft pouch
Laser visibility glasses

4 Technical data

Right of technical changes reserved.
Technical data
Power supply
Battery condition check
Measuring range
Typical measuring range without target plate
Accuracy
Smallest unit displayed
Beam diameter
Basic operating modes
Display
Laser
Automatic cut-out
Battery life
Operating temperature range
Description
PDA 50
PDA 51
PDA 52
PDA 71
Description
PDA 60
PDA 65
PUA 60
Values
3V DC AA-size batteries
Battery condition indicator with 4 segments show-
ing 100%, 75%, 50%, 25% charge : No segments
shown: The batteries are exhausted
0.05...200 m
Drywall panel, white: 100 m
Concrete, dry: 70 m
Brick, dry: 50 m
Typically ±1.0 mm for single and continuous measure-
ment
1 mm
Beam length 10 m: Max. 6 mm
Beam length 50 m: Max. 30 mm
Beam length 100 m: Max. 60 mm
Single measuring, continuous measuring,
calculation/functions
Illuminated dot-matrix display with permanent indica-
tion of operating mode and battery condition
Visible 635 nm, Output power less than 1 mW: Laser
class 2
IEC 825‑ 1:2007; CFR 21 § 1040 (FDA)
Laser: 1 min
Tool: 10 min
Max. number of measurements with laser beam
switched on for a time of 10 s Alkaline 8,000...
10,000 NiMH 6,000...8,000
-10...+50°C
en
19