Table des Matières
Publicité
32
Fig.15
ASSEMBLY OF CUTTING
UNITS TO MACHINE
1.
FITTING FIXED AND FLOATING HEADS
TO LIFT ARM
a.
Fit two O Rings (12) into mounting head.
Lubricate O Rings (12) & pivot shaft (B).
b.
Feed mounting head (G, H or J) onto shaft
(B) making sure O Rings (12) remain in the
recesses. Make sure spacer (C) is located
between mounting head (G, H or J) and lift
arm.
c.
Fit collar (D) to shaft (B) to retain mounting
head on lift arm and secure using screw (E)
and s.l.washer (F)
d.
Lubricate unit mounting head with Shell
Retinax 'A' grease.
2.
FITTING CUTTING UNIT TO LIFT ARM /
MOUNTING HEAD
a.
Position cutting unit under lift arm / mounting
head.
b.
Lower lift arm / mounting head to cutting unit
and align mounting holes.
c.
secure cutting unit to mounting head using
four screws (4), s.l.washers (11) and washers
(28)
3.
FITTING DRIVE MOTOR TO CUTTING
UNIT
a.
Remove shipping plate from drive motor.
b
Align drive motor spline(A) to cutting cylinder
shaft (17), lubricate spline with Shell S7222
grease.
e.
Secure drive motor (A) to bearing housing
with two screws M10 x 30 (18) & two
Washers (19).
4.
FITTING DEFLECTORS TO CUTTING UNIT
a.
Assemble two Bolts (2) & two Spacers (3) into
each end of Deflector (22).
b.
Fit Deflector (22) between unit side plates
aligning flats on bolt with flats in the holes.
c.
Push Bolts (2) through side plates with a
suitable rod.
d.
Secure with Stiffnuts (3) tighten until
Deflector (22) becomes stiff to move.
GB
Publicité
Table des Matières
