Ransomes PARKWAY 2250 Manuel D'utilisation page 50

48
Fig.25
Fig.26
Fig.27
Fig.28
HYDRAULIC SYSTEM
Check hydraulic fluid level in plastic sight tube.
Keep fluid level about 1/2 way up sight tube S
Fig.25
Remove plug to drain hydraulic fluid.
Fill through filler cap B Fig.25 on top of tank.
Hydraulic fluid filter is cartridge type. Replace
entire unit as needed.
1. When changing filter element, fill filter with
clean hydraulic fluid.
2. Start engine and idle for 15 seconds.
3. Stop engine and check reservoir level.
4. Start engine and idle for another 15 seconds.
5. Stop engine and check reservoir
6. Start engine and idle for 5 minutes to remove
air from hydraulic system.
7. Check reservoir level again.
Hydraulic Test Ports - Available to check hydraulic
pressure in the following systems:
A Fig.26 - Reel drive pressure 207bar (3,000
psi)
B Fig.27 Four wheel drive pressure reverse
207bar (3,000 psi)
B Fig.28 Four wheel drive pressure forward
207bar (3,000 psi)
A Fig.28A - Lift and power steering 86bar
(1250 psi).
Fig.28A
GB GB
GB GB GB