Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
do so, unscrew all screws anti-clockwise us-
ing a cross head screwdriver.
Carefully remove the rechargeable battery
compartment cover. Ensure that you do not
damage the wiring. Take out the used or
exhausted rechargeable battery
Insert a Ni-MH, AA, 1.2 V
chargeable battery (included in delivery) into
the rechargeable battery compartment
Note: Ensure correct polarity. This is indicated
in the rechargeable battery compartment
Place the cover back onto the rechargeable
battery compartment
screws clockwise by means of a cross head
screwdriver.
Make sure that the cables do not get
jammed when you shut the solar casing
Insert the lower standpipe
decoration with light bar
Fig. A).
Trouble-shooting
= Problem
= Cause
= Solution
The product does not come on
when it is dark, even though it was
exposed to sunlight all day.
Artificial sources of light such as street light-
ing or similar are making the Photosensor
believe it is still daylight.
Place the product somewhere where it is
shielded from artificial sources of light.
The product only comes on for a
short time or not at all.
The rechargeable battery is flat or there is
not enough daylight to recharge the
rechargeable battery.
Replace the rechargeable battery or place
the product in a sunnier position.
This product has some very sensitive electrical
parts. That is why interference may occur if the
.
10
/ 400 mAh re-
.
9
.
9
again and turn all
9
.
4
back into the
6
again (see
1
product is set up near devices that transmit
radio signals. Remove these devices if interfer-
ence occurs.
Electrostatic discharge may possibly cause dis-
turbances to the product. If such disturbances
occur, remove the rechargeable battery for a
few seconds and then re-insert it (see "Replac-
ing the rechargeable battery").
Cleaning and care
Do not use any solvents, petrol or similar.
This would cause damage to the product.
Only use a dry, lint-free cloth to clean the
product.
Alternatively, a feather duster can be used
for cleaning the decora tion with light bar
If the product is more severely soiled, you
may have to use a slightly damp cloth and
a mild detergent.
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a)
and numbers (b) with following
meaning: 1–7: plastics / 20–22:
paper and fibreboard / 80–98:
composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
.
1
GB/IE/NI
9
Publicité
Chapitres
Table des Matières
