Assembly; How To Use; Switching The Product On And Off; Charging Rechargeable Battery - MELINERA HG02998A Instructions D'utilisation Et Consignes De Sécurité

Assembly

Insert the lower standpipe
decoration attachment with light bar
(see Fig. A).
Unfold the solar casing
Use the ground spike
uct with into the ground (lawn, flower bed,
etc.).
Note: Ensure that the product stands firmly
in place. Do not use any force when assem-
bling or setting up the product, e.g. hammer
blows. This damages the product.
Note: For the best results, put the product
in a place where the solar cell
to direct sunlight for as long as possible. Do
not put the product under bushes, trees,
canopies etc. as this reduces the incidence
of incoming sunlight.
Position the product in such a way that the
solar cell is not covered or in the shade.
3
Note: Make sure that the solar cell
not near another source of light such as
street or garden lighting as the product will
otherwise not switch itself on automatically
when it starts to get dark.

How to use

Switching the product
on and off
Note: Remove the protective film from solar
cell before use.
3
Switch the ON / OFF switch
tom of the solar casing
OFF position to switch the product on or off.
Note: If the ON / OFF switch
ON position, then the product switches on
automatically in the dark.
Note: Switch the product off (OFF posi-
tion) if the product will be in the dark for
any length of time (e.g. when transporting it
with a rechargeable battery inserted) or the
8 GB/IE/NI
into the
6
1
(see Fig. A).
4
to place the prod-
7
is exposed
3
is
3
on the bot-
5
into the ON or
4
is in the
5
burn time is not satis factory due to a very
short incidence of light.
Charging rechargeable
battery
Open the solar casing
position.
Switch the ON / OFF switch
tom of the solar casing
sition to recharge the rechargeable battery.
Note: The solar cell
that is as direct as possible to recharge the
rechargeable battery
the best possible results, place the product
in a place where the solar cell
to direct sunlight for as long as possible.
The rechargeable battery
using the solar cell
3
of the sunlight and the angle of incidence of the
light on the solar cell
give off light for about 8 hours with a fully
charged rechargeable battery.
Place the solar cell
possible to the angle of incidence of the
light. In this way you will receive the highest
light levels.
Replacing the rechargeable
battery (Fig. B and C)
Note: For this step, you will need a cross head
screwdriver.
Switch the product off by means of the
ON / OFF switch
inserting the rechargeable battery
Fold the solar casing
decoration with light bar
Pull the lower standpipe
tion with light bar
Open the rechargeable battery compartment
on the bottom of the solar casing
9
into a horizontal
4
on the bot-
5
into the ON po-
4
requires sunlight
3
. In order to get
10
is exposed
3
charging period
10
depends on the intensity
. The product should
3
as perpendicular as
3
before removing or
5
.
10
up against the
4
.
1
off the decora-
6
.
1
4
. To