Installation Procedure - Franke CRYSTAL FH CR 301 1TC Manuel D'installation

EN
FH CR 301 1TC / 302 2G / 604 4G / 755 4G TC / 905 4G TC / 1204 3G TC
Ventilation of rooms
Make sure the room where the appliance
is installed has permanent ventilation
openings towards the outside or
ventilation ducts to ensure an adequate
air flow, as prescribed by the current
regulations. All openings made must:
– Have a section of at least 100 cm
– Be made in such a way that they
cannot be obstructed from inside
or outside;
– Be provided with suitable protection
to ensure that the ventilation
opening is not reduced;
– Be at a suitable height from floor
so that they do not hinder the
exhausting of fumes.
If openings are made in the wall of an
adjacent room, the latter must have
direct ventilation and must not be:
– A bedroom
– A common area of the building
– A fire hazard area
Before testing and inspecting the
appliance, make sure the room in which
the ventilation opening is made does not
have low pressure due to the operation
of another user and that the ventilation
between the two rooms is guaranteed by
permanent free openings, for example
by increasing the gap between the
bottom of the door and the floor. The
exhausting of fumes must occur by
means of a hood which, in turn, must be
connected to a chimney, flue, or directly
to the outside.

Installation procedure

The appliance is fixed to the unit by
means of the brackets and accessories
provided.
Make sure that there is free access to
X X
the two fixing elements in front after
the installation of the appliance.
1
Prepare the hole in the worktop
X X
according to the dimensions
;
2
indicated.
Mill the worktop along the entire
X X
edge of the hole made for built-in
installation. Be sure to comply with
the dimensions indicated.
2
Refer to the information in chapter
X X
„Connection to gas supply" before
connecting the appliance.
Connect the appliance to the gas
X X
supply.
– 6 –