Safety Information; Proper Installation And Placement - Franke CRYSTAL FH CR 301 1TC Manuel D'utilisation

EN

SAFETY INFORMATION

Read the operating instructions before
Z X
using the appliance for the first time.
The manufacturer can not be made liable for
possible damage which may occur due to
incorrect installation and incorrect, improper
or unreasonable use of the device.
To ensure safe and efficient operation of this
electrical device:
Only contact authorised service centres.
Z X
Do not modify any features of the device.
Z X
This appliance is not intended for use
by persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
This device is not a toy.
Keep children away from the device and
Z X
the packaging material.
Do not leave children near the device
Z X
unattended.
Do not let children play with the device.
Z X
Do not allow children to touch the device
Z X
or its controls during and immediately after
using it, since the hob becomes very hot.
Do not allow children to touch an unused
Z X
device. Make any potentially hazardous
parts safe.

Proper installation and placement

The appliance must be installed and
connected to the electricity and gas supply
in accordance with the separate installation
instructions. Have a qualified fitter/
electrician carry out the necessary work.
The appliance is designed for use in the home
for preparing food. No liability is assumed
for any damage caused by improper use or
incorrect handling.
FH CR 301 1TC / FH CR 302 2G / FH CR 604 4G /
FHCR 755 4G TC / FHCR 905 4G TC / FHCR 1204 3G TC
– 4 –
If the appliance is to be permanently
connected to the power supply:
Ensure that the device is installed only
Z X
by the customer service, an electrician
or trained personnel with the appropriate
knowledge/education.
This appliance is not connected to a
Z X
combustion products evacuation device.
It shall be installed and connected in
accordance with current installation
regulations. Particular attention shall
be given to the relevant requirements
regarding ventilation.
Ensure that the device is installed in a way
Z X
that allows to disconnect it from the power
supply, with a contact opening distance
that ensures complete disconnection in
category III overvoltage conditions.
Ensure that the appliance is connected to
Z X
an earthing system in compliance with the
current regulations.
Ensure that the device is connected
Z X
directly to the mains socket.
– Ensure that no adapters, no multi-
sockets and no extension cables are
used to connect the device.
Ensure that the supply cord is not
Z X
damaged. If damaged, contact customer
services.
Ensure that the device is not exposed to
Z X
atmospheric agents (rain, sun).
Ensure that the ventilation of the appliance
Z X
is in accordance with the manufacturer's
instructions.
CAUTION! The use of a gas cooking
Z X
appliance results in the production of heat,
moisture and products of combustion in
the room in which it is installed.
Ensure that the kitchen is well ventilated
Z X
especially when the appliance is in use:
keep natural ventilation holes open or
install a mechanical ventilation device
(mechanical extractor hood).
Ensure the gas type and supply is
Z X
compatible with appliance specifications.