Table des Matières
Publicité
FH FS 865 / FH FS 864 / FH FS 784 / FH FS 584
Installation procedure
Explanation for positions in illustrations (page 5 and 6)
Oven
a
Kitchen furniture
s
Triphase connection
d
Monophase connection
f
The appliance is fixed to the unit by means of the clamps and provided installation
materials.
Make sure that there is free access to the fixing elements in front after the
X
X
installation of the appliance.
1
Refer to the information in chapter „Electrical connection" before connecting the
X
X
appliance.
Connect the appliance like shown in the diagram (in accordance with the mains
X
X
voltage).
2
Prepare the hole in the worktop according to the dimensions indicated.
X
X
In the case of flush installation: Mill the worktop along the entire edge of the hole
X
X
made for built-in installation. Be sure to comply with the dimensions indicated.
In the case of flush installation: Seal the hole with the silicon adhesive tape gasket
X
X
that is supplied with the product or in alternative apply silicon sealant (not included
in the product).
In the case of slim top installation: Only apply the silicon sealant.
X
X
3
Fit the appliance in the worktop correctly.
X
X
Fix the appliance with the screws and clamps.
X
X
In the case of flush installation: Apply silicone around the entire perimeter of the
X
X
recess.
This will prevent water from seeping in and ensure the appliance adheres properly to
the top.
All manuals and user guides at all-guides.com
– 9 –
EN
Publicité
Table des Matières
