WIKA DMSU21SA Mode D'emploi page 31

8. Configuration via display and operating unit
13. Select "Low" and confirm with [↵].
14. Select "change" and confirm with [↵].
15. Set the start of the measuring range referred to the filling
height of the tank.
Set digits using [▲] [▼] and confirm with [↵].
» The cursor moves to the next digit.
» Repeat for each digit.
» Start of the measuring range is set.
16. Go back one menu level using [ESC].
Select "High" and confirm with [↵].
17. Select "Change" and confirm with [↵].
18. Set the end of the measuring range referred to the filling
height of the tank.
Set digits using [▲] [▼] and confirm with [↵].
» The cursor moves to the next digit.
» Repeat for each digit.
» End of the measuring range is set.
19. Go back two menu levels using [ESC].
Select "Characteristic" and confirm with [↵].
20. Select characteristic curve and confirm with [↵].
» Characteristic curve is set.
→ Explanation of characteristic curves, see chapter 8.4
"Characteristic curves"
21. Select "Scale out" and confirm with [↵].
22. Select "Unit" and confirm with [↵].
23. Select volume unit and confirm with [↵].
Volume unit: Standard units (e.g. litres, m³, ...)
■
Free input: Freely definable unit (selectable under
■
"Volume unit")
» Volume unit is set.
WIKA operating instructions, model DMSU21A
EN
31