Care And Cleaning; Disposal - TOOLCRAFT ZD-8916 Notice D'emploi

• Carefully insert a new tip onto the ceramic heating element.
• Replace the sleeve and carefully turn the metal nut with your hand to secure the tip in place. Do not use any force
or tools when screwing the nut.
Replacement soldering tip have the following Conrad item number: 1694194 (see "Technical data").

10. Care and cleaning

Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may damage the
casing or stop the product from functioning properly.
• The soldering station is maintenance-free, except for the occasional replacement of the soldering tip.
• Maintenance or repair work must be done by a technician or a specialist repair centre. Under no circumstances
should you service any of the components in the interior of the product, therefore never open/dismantle it.
• Do not clean the product by immersing it in water.
• Use a slightly damp, lint-free cloth to clean the exterior of the product. Dust can be easily removed using a soft,
clean long-haired brush and a vacuum cleaner. Only use a small amount of water when cleaning the product.
• Before cleaning the soldering station, switch it off and unplug the power adapter to disconnect it from the mains.
Allow the soldering iron and soldering station to cool down completely.
• The soldering tip does not require any special cleaning. It is sufficient to clean it occasionally by using the wire
sponge to remove flux residues or excess solder.
• The soldering tip must be coated with tin before the soldering station is switched off. This prevents corrosion on
the soldering tip.

11. Disposal

Electronic devices are recyclable waste and must not be placed in household waste. Always dispose of the
product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
23