Table des Matières
Publicité
25
23
35
33
37
36
35
201
34
32
33
31
30
71
27
72
TABLE 1 - TABLEAU 1 - TABELLE 1 - TABLA 1 - TAVOLA 1
24
20
19
38
22
21
202
28
27
2. INSTRUCTIONS FOR USE
2.1) Setting
44
With the tool in the rest position
48
– Select the appropriate die set for the connector.
– Insert the die (91) in the upper seat of the tool head until it is locked by die/head pin (32).
To ease the die insertion, keep die/head release pin (30) depressed.
49
70
– Operate moveable handle (203) (see § 2.2) to advance the ram (202) 8-10 mm (0.3 - 0.4 in.)
46
and insert the die (90) into the seat on the ram until it is locked by die/ram retaining pin (37).
16
69
To ease this operation, keep die/ram release pin (36) depressed.
15
– Insert the conductor in the connector.
16
14
– Position the connector between the dies and ensure the correct location of the crimp.
15
42
2.2) Die advancement
14
41
– Set the tool in the release position
13
The moveable handle (203) will be released and the main handle will rotate automatically
39
12
to the operating position
11
– Operate moveable handle (203) for lower die advancement. This first stage rapidly closes
the dies to the connector.
N
ever place the tool uNder pressure without iNsertiNg the dies
could cause damage to the head aNd the ram
61
Make sure that dies are exactly positioned on desired crimp point, otherwise re-open
62
18
63
dies following instructions as per § 2.4 and position the connector again.
12
17
64
2.3) Crimping
34
– Continue operating the moveable handle (203). The tool will automatically change over to
the high pressure stage. The ram will advance until the dies meet.
7
– It is recommended to continue pumping until the maximum pressure valve is activated
and a "click" is heard.
2.4) Dies re-opening
– Rotate the fixed handle to release position
will then retract, with the consequent opening of the dies.
2.5) Rest setting
– Retract thoroughly the ram, operating as per § 2.4.
73
– Keeping the handles completely closed, release the fixed handle which will rotate au-
tomatically to the rest position
of the handle latch (49).
– Store the tool in the case.
4
(Ref. to Fig. 1 and 2)
46
operate as follows:
50
203
51
52
68
43
65
66
67
by rotating the fixed handle (200).
40
53
54
.
17
55
55
59
.
56
57
58
8
11
10
10
9
60
. Close handles thoroughly: the ram
3
2
. The moveable handle will then be locked by means
200
ENGLISH
,
as this
1
Publicité
Table des Matières
