MZ electronic EV-011 Instructions D'utilisation page 26

Setting up to count in feet
1
Press
2
Press
3
Then the gipsy circumference
programmed in the factory (13")
will be displayed.
4
Press
number on
reaching the value corresponding
to the length of chain on the gipsy.
Press
value by one unit (e.g. 12").
5
Then the division factor will be
displayed.
If you use the 3-wire inductive
sensor set here the number of
signatures of the gypsy obtained
from Table 1.
If you use the 2-wire magnetic
sensor leave the value set to 1.
6
On reaching the set value wait for
5 seconds.
INCHES will run across the display
screen.
7
At this point the instrument will set
up to count chain deployment in
feet – in 1, 2 or 3 foot increments
depending on the size of the gipsy.
EV-011
for three second.
.
to increase the
the display until
to decrease the set
The words SET
26
English
Rev. 11– 2017