MZ electronic EV-011 Instructions D'utilisation page 25

Setting up to count in metres
1
Press
2
Then the gipsy circumference
programmed in the factory (33 cm)
will be displayed.
3
Press
number on
reaching the value corresponding
to the length of chain on the gipsy.
Press
value by one unit (e.g. 32 cm).
4
Then the division factor will be
displayed.
If you use the 3-wire inductive
sensor set here the number of
signatures of the gypsy obtained
from Table 1.
If you use the 2-wire magnetic
sensor leave the value set to 1.
5
On reaching the set value wait for
5 seconds. The words SET CM will
run across the display screen.
6
At this point the instrument will set
up to count chain deployment in
metres – in 0.5 m increments up to
99.5 metres and 1 m increments
up to 999 metres.
EV-011
for three second.
to increase the
the display until
to decrease the set
25
English
Rev. 11– 2017