Checking The Contents - Ivoclar Vivadent UTS 3D Mode D'emploi

4. Assembly and Initial Start-Up
4.1

Checking the contents

Check the delivery for completeness:
– 1 Universal transferbow, complete
– 1 Nosepiece, complete
– 1 Reference indicator
– 1 3D-Registration joint
– 1 3D-Bite fork
– 2 Earpieces with support, complete
– 5 Nosepads, green (medium)
– 5 Nosepads, blue (soft)
– 1 Instructions for Use
4.2 Assembly and initial start-up
Mount earpieces
Mount the desired earpieces (6.3) (M or L) on the
threaded pins for earpieces (6.4). Loosen the earpiece rod
screw (1.2) and mount the entire assembly on the ear-
piece mounting (1.1). Make sure the earpieces are
correctly positioned.
6.4
1.2
6.1
Attach nosepiece with nosepads
Place the desired nosepad (10.1 or 10.2) in the nosepad
holder (2.3). Insert the nosepiece rod (2.2) into the
nosepiece holder (2.1).
2.1
The nosepiece holder (2.1) may now be attached to the
connection for the nosepiece (1.9) using the nosepiece
holder screw (1.10) of the multifunctional mounting (1.6).
6.3
1.1
2.2
2.3 10.0
2.1
1.6
1.8
Reference indicator
Mount the reference indicator (3.0) on the thread for screw
3.1 (1.12) by means of the reference indicator screw (3.1).
3.0
3D-registration joint with bite fork
Insert the connector (8.1) of the bite fork (8.0) into the
bite fork connector (7.5) and tighten the bite fork
connector screw (7.4). Insert the connector (7.1) into the
registration joint connection (1.8) and secure the 3D-
registration joint (7.0) with the registration joint connec-
tion screw (1.11).
7.1
7.2
Axis pins
The axis pins (4.0) are mounted in the laboratory if the
UTS 3D is directly connected to the articulator.
When using the UTS 3D on the patient, the axis
pins (4.0) must not be used in order to prevent
injury.
1.10
1.9
3.1
7.4
8
7.5
7.3
8.1
1.12
9