Changing The Saw Blade; Adjust Pendulum Guard - Festool HKC 55 EB Notice D'utilisation Originale

English
8.4

Adjust pendulum guard

CAUTION
Risk of injury! Sharp edges!
The pendulum guard swings back quickly in
the event of sudden release.
► The pendulum guard [1-6] must only be
opened with the retractor lever [1-4].
8.5 Selecting the saw blade
Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
WARNING! Risk of injury! Pendulum hood
mechanism not working correctly! Diamond
saw blades must not be used to saw cement-
bonded fibreboard.
Colour
Yellow Wood
Red Laminate, mineral ma­
terial
Green Plaster and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
14
4
0° - 50°
4-1
4-2
Material Symbol
HPL/TRESPA
ACRYL
8.6

Changing the saw blade

Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
Removing the saw blade
► Swivel saw to 0° position before replacing
the saw blade and set maximum cutting
depth.
► Position saw on motor cover when replac­
ing [5-1].
► Turn the lever [5-4] as far as the stop.
► Open the screw [5-8] using the Allen
key [5-3].
► Hold the pendulum guard open [5-7] only
with retractor lever [5-5].
► Remove the saw blade [5-9].
Inserting the saw blade
WARNING! Check the screws and flange for
contamination and only use clean and undam­
aged parts.
► Insert the new saw blade.
WARNING! The direction of rotation of the
saw blade [5-10] and saw [5-6] must
match. Serious injuries may occur in the
event of non-compliance.
► Insert the outer flange [5-11] so that the pin
engages in the recess on the inner flange.
► Release retractor lever [5-5] and allow the
pendulum guard [5-7] to swivel back to its
final position.
► Tighten the screw [5-8].
► Reposition the lever [5-4].
®
WARNING
CAUTION