Changing The Saw Blade - Festool TS 55 FEQ Notice D'utilisation D'origine

English
4
0° - 45°
4-1
4-2
47°
-1°
4-3
8.4 Selecting the saw blade
Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Refer to the necessary saw blade data (see sec­
tion 4.1 ).
Colour Material
Yellow Wood
Red Laminate, mineral ma­
terial
Green Plaster- and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
8.5

Changing the saw blade

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
14
4-1
-1°
-1° / 47°
Symbol
HPL/TRESPA
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Remove the saw blade
► Swivel the machine to 0° before replacing
the saw blade and adjust the maximum cut­
ting depth.
► Turn the lever [5-2] as far as it will go.
► Slide the safety lock [5-1] upwards and
push the saw unit downwards until it clicks
into place.
► Loosen the screw [5-5] using the Allen
key [5-3].
► Remove the saw blade [5-7].
4-4
5
5-4
5-5
5-7
®
5-8
5-9
Inserting the saw blade
WARNING! Check the screws and flange for
contamination and only use clean and undam­
aged parts.
► Insert the new saw blade.
WARNING! The direction of rotation of the
saw blade [5-8] and saw [5-6] must match.
Serious injuries may occur in the event of
non-compliance.
CAUTION
5-1
5-2
5-3
5-6