Adjusting The Cutting Depth; Adjusting The Cutting Angle - Festool HKC 55 EB Notice D'utilisation Originale

8 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the battery packs from
the machine before performing any type of
work on the machine!
8.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The HKC 55 EB is fitted with an electronic
brake. When the saw is switched off, the saw
blade slows to a stop electronically within ap­
prox. 2 seconds.
Restart protection
The integral restart protection prevents the
electric power tool from automatically starting
up again after an interruption in power when
the ON/OFF switch is pressed. In this case the
electric power tool must be switched off and
then switched back on again.
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the motor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
8.2

Adjusting the cutting depth

The cutting depth can be set at 0-2-3/16" (0 –
55 mm).
► Press cutting depth adjustment [3-1].
► Pull up or push down saw at main handle.
Cutting depth without guide rail/track
rail
max. 2-3/16"(55 mm)
Cutting depth with guide rail/track rail
+FS max. 2-1/32" (51 mm)
+FS
8.3

Adjusting the cutting angle

The saw table must be on an even surface
when adjusting the cutting angle.
between 0° and 50°:
► Open knob [4-2].
► Swivel sawing unit to the desired cutting an­
gle [4-1].
► Close knob [4-2].
Both positions (0° and 50°) are set at the
factory and can be readjusted by the after-
sales service team.
For angled cuts, the cutting depth is
smaller than the value displayed on the
cutting depth scale.
English
3
3-1
13