► Slowly push saw along the entire length of
the rail.
The edge of the splinterguard now corresponds
exactly to the cutting edge.
11.3 Cross cutting guide rail
The cross cutting guide rail is designed for saw
ing wood and panel materials.
It enables precise and clean cuts, in particular
angled cuts can be performed simply and with
repeat accuracy. The saw automatically moves
back to the initial position after the sawing
process.
Observe the instructions in the operating man
ual for the FSK cross cutting guide rail
11.4 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro
vides protection and storage for the tool and ac
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
Turn the T-loc [SYS-b-1] to this posi
tion.
To lock the Systainer
Turn the T-loc [SYS-b-1] to this posi
tion.
To connect two Systainers
Place one Systainer on the top of the other
(Fig. [SYS-a]).
Turn the T-loc [SYS-b-1] to one of
this positions (Fig. [SYS-b]).
The Systainers are connected and locked.
A new generation Systainer is connectable
on top of a previous generation Systainer
by the four latches of the previous
Systainer.
SYS-b-1
12 Environment
Do not dispose of the device together with do
mestic waste! Dispose of machines, accesso
ries and packaging at an environmentally re
sponsible recycling centre. Observe the valid
national regulations.
Battery Disposal
WARNING
Risk of fire or injury
► Do not attempt to disassemble the battery
or remove any component projecting from
the battery terminals.
► Prior to disposal, protect exposed termi
nals with heavy insulating tape to prevent
shorting.
13 General information
13.1 Information on data protection
The power tool contains a chip which automati
cally stores machine and operating data. The
English
SYS-a
SYS-b
19