Temperature And Moisture; Ice And Water - Jennair W10779525B Guide D'utilisation Et D'entretien

TROUBLESHOOTING

TEMPERATURE AND MOISTURE

TEMPERATURE IS TOO WARM
New installation? Allow 24 hours following
■
installation for the refrigerator to cool
completely.
Door(s) opened often or left open? Allows
■
warm air to enter refrigerator. Minimize
door openings and keep doors fully closed.
Large load of food added? Allow several
■
hours for refrigerator to return to normal
temperature.
Controls set correctly for the surrounding
■
conditions? Adjust the controls a setting
colder. Check temperature in 24 hours. See
"Using the Controls."
Refrigerator not cooling? For models with
■
digital controls, turn the refrigerator off and
then on to reset. If this does not correct the
problem, call for service.
Air vents blocked? Remove any item from
■
in front of the air vents.
THERE IS INTERIOR MOISTURE BUILDUP
NOTE: Some moisture buildup is normal.
Humid room? Contributes to moisture
■
buildup.
Door(s) opened often or left open? Allows
■
humid air to enter refrigerator. Minimize
door openings and keep doors fully closed.

ICE AND WATER

THE ICE MAKER IS NOT PRODUCING ICE OR
NOT ENOUGH ICE
Refrigerator connected to a water supply
■
and the supply shutoff valve turned on?
Connect refrigerator to water supply and
turn water shutoff valve fully open.
Kink in the water source line? A kink in the
■
line can reduce water flow. Straighten the
water source line.
Ice maker turned on? Make sure wire
■
shutoff arm or switch (depending on
model) is in the ON position.
New installation? Wait 24 hours after ice
■
maker installation for ice production to
begin. Wait 72 hours for full ice production.
Large amount of ice recently removed?
■
Allow 24 hours for ice maker to produce
more ice.
Ice cube jammed in the ice maker ejector
■
arm? Remove ice from the ejector arm with
a plastic utensil.
Reverse osmosis water filtration system
■
connected to your cold water supply?
This can decrease water pressure. See
"Water Supply Requirements" in either the
Installation Instruction booklet or the Use &
Care Guide.
THE ICE CUBES ARE HOLLOW OR SMALL
NOTE: This is an indication of low water
pressure.
Water shutoff valve not fully open? Turn
■
the water shutoff valve fully open.
Kink in the water source line? A kink in the
■
line can reduce water flow. Straighten the
water source line.
Reverse osmosis water filtration system
■
connected to your cold water supply? This
can decrease water pressure. See "Water
Supply Requirements."
Questions remain regarding water
■
pressure? Call a licensed, qualified plumber.
ICE IS STICKING TOGETHER IN THE ICE
STORAGE BIN
It is normal for frost to be on top of the ice
■
storage bin due to normal opening and
closing of the freezer.
It is normal for ice to stick together when
■
it is not dispensed or used frequently. It is
recommended that the ice storage bin be
emptied and cleaned as needed. See "Ice
Maker and Storage Bin."
OFF-TASTE, ODOR OR GRAY COLOR IN THE ICE
New plumbing connections? New
■
plumbing connections can cause
discolored or off-flavored ice.
Ice stored too long? Discard ice. Wash ice
■
bin. Allow 24 hours for ice maker to make
new ice.
Odor transfer from food? Use airtight,
■
moisture proof packaging to store food.
Are there minerals (such as sulfur) in
■
the water? A water filter may need to be
installed to remove the minerals.
Is there a water filter installed on the
■
refrigerator? Gray or dark discoloration in
ice indicates that the water filtration system
needs additional flushing.
TROUBLESHOOTING | 29