Jennair W10779525B Guide D'utilisation Et D'entretien page 17

GETTING STARTED
3.
Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for
up to 10 seconds after removing the glass
from the pad. The dispenser may continue
to make noise for a few seconds after
dispensing.
DISPENSER TRAY (ON SOME MODELS)
Some models have a tra y at the bottom of the
dispenser area. The tray is designed to catch
small spills and is removable for easy emptying
and cleaning.
NOTE: There is no drain in the tray.
DISPENSER LIGHT (ON SOME MODELS)
When you use the dispenser, the light will
automatically turn on. If you want the light to
be on continuously, you may choose either ON
or AUTO.
ON: Press LIGHT to turn the dispenser light on.
AUTO: Press LIGHT a second time to select
AUTO mode. The dispenser light will
automatically adjust to become brighter as
the room brightens and dimmer as the room
darkens.
OFF: Press LIGHT a third time to turn the
dispenser light off.
The dispenser lights are LEDs that cannot
be changed. If it appears that your dispenser
lights are not working, be sure that the light
sensor is not blocked (in AUTO mode). See
"Troubleshooting" for more information.
WATER FILTER STATUS LIGHT
The water filter status light and display screen
help you know when to change your water
filter. Press the FILTER button to check the
status of your water filter.
If the filter is new:
You must press FILTER to view the filter's
status. For a few seconds, the status light will
be blue and the display screen will show what
percentage of your filter's life remains.
If it is almost time to change the filter:
The status light will automatically illuminate
and will remain on, appearing yellow. The words
"ORDER FILTER" will appear on the display
screen. Press FILTER to see what percentage
of your filter's life remains. You should order
the appropriate replacement filter. See
"Accessories."
If it is time to change the filter:
The status light will remain on, changing to
red. The words "REPLACE FILTER" and "HOLD
BUTTON TO RESET" will appear on the display
screen until the filter has been changed and
the status light has been reset.
To reset the water filter status light:
After changing the filter, reset the status light
by pressing and holding the FILTER button for
3 seconds. The status light will blink red and
change to blue, and then turn off when the
system is reset.
GETTING STARTED | 17